[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[debian-users:30747] 無線LANでのAd-Hocモードが確立しません



  禮田です。

  下記環境のPC間で無線LAN(Ad-Hocモード)での通信が出来ません。
どなたか原因をご存じの方がいらっしゃいましたらご教示下さい。

  PC2とほぼ同一設定のPCにWLI-PCM-L11GPを挿入した場合はAd-Hocモードでの
通信が確立していますので、PC1の設定があやしいと思っているのですがこれ
以上どこをいじってよいやらわかりません...

  よろしくお願い致します。

-----PC1-----
インストールされているパッケージ
ii  kernel-patch-2 0.9.10-1       ext3fs support for Linux 2.4.10
ii  kernel-source- 2.4.10-1       Linux kernel source for version 2.4.10
ii  pcmcia-cs      3.1.22-0.1pota PCMCIA Card Services for Linux.

無線LANカード
MELCO WLI-PCM-L11GP

/boot/config-2.4.10の内容
# Wireless Pcmcia cards support
CONFIG_PCMCIA_HERMES=m
CONFIG_NET_WIRELESS=y

/etc/pcmcia/configへの追加部分
device "orinoco_cs"
  class "network" module "orinoco_cs"
card "MELCO WLI-PCM-L11"
  version "MELCO", "WLI-PCM-L11"
  bind "orinoco_cs"

カード挿入時のsyslog
Nov 21 23:55:56 cyberia cardmgr[3975]: initializing socket 0
Nov 21 23:55:56 cyberia cardmgr[3975]: socket 0: MELCO WLI-PCM-L11
Nov 21 23:55:56 cyberia cardmgr[3975]: executing: 'modprobe orinoco_cs'
Nov 21 23:55:56 cyberia kernel: hermes.c: 1 Aug 2001 David Gibson <hermes@xxxxxxxxxxxxxxxxxxxxx>
Nov 21 23:55:56 cyberia kernel: orinoco.c 0.07 (David Gibson <hermes@xxxxxxxxxxxxxxxxxxxxx> and others)
Nov 21 23:55:57 cyberia kernel: orinoco_cs.c 0.07 (David Gibson <hermes@xxxxxxxxxxxxxxxxxxxxx> and others)
Nov 21 23:55:57 cyberia kernel: eth0: Station identity 001f:0001:0007:001c
Nov 21 23:55:57 cyberia kernel: eth0: Looks like a Lucent/Agere firmware version7.28
Nov 21 23:55:57 cyberia kernel: eth0: Ad-hoc demo mode supported.
Nov 21 23:55:57 cyberia kernel: eth0: IEEE standard IBSS ad-hoc mode supported.
Nov 21 23:55:57 cyberia kernel: eth0: WEP supported, "128"-bit key.
Nov 21 23:55:57 cyberia kernel: eth0: MAC address 00:02:2D:3D:1E:56
Nov 21 23:55:57 cyberia kernel: eth0: Station name "HERMES I"
Nov 21 23:55:57 cyberia kernel: eth0: ready
Nov 21 23:55:57 cyberia cardmgr[3975]: executing: './network start eth0'
Nov 21 23:55:57 cyberia kernel: eth0: index 0x01: Vcc 5.0, irq 5, io 0x0100-0x013f
Nov 21 23:55:57 cyberia cardmgr[3975]: + ioctl: Operation not supported
Nov 21 23:55:57 cyberia kernel: bridge-eth0: found peer eth0
Nov 21 23:55:57 cyberia kernel: bridge-eth0: up

カード挿入時のiwconfig
eth0      IEEE 802.11-DS  ESSID:"non-specified SSID !!"  Nickname:"HERMES I"
          Mode:Ad-Hoc  Frequency:2.412GHz  Cell: 02:02:2D:3D:1E:56
          Bit Rate:2Mb/s   Tx-Power=15 dBm   Sensitivity:1/3  
          Retry limit:4   RTS thr:off   Fragment thr:off
          Power Management:off
          Link Quality:0  Signal level:0  Noise level:0
          Rx invalid nwid:0  invalid crypt:0  invalid misc:0

カード挿入時のifconfig
eth0      Link encap:Ethernet  HWaddr 00:02:2D:3D:1E:56  
          inet addr:192.168.36.36  Bcast:192.168.36.255  Mask:255.255.255.0
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:0 errors:0 dropped:0 overruns:0 frame:0
          TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:100 
          RX bytes:0 (0.0 b)  TX bytes:0 (0.0 b)
          Interrupt:5 Base address:0x100 
-----PC1-----

-----PC2-----
インストールされているパッケージ
ii  kernel-patch-2 20010504-1     Andre Hedrick's IDE patch.
ii  kernel-patch-2 3.5.32-2       ReiserFS support for Linux 2.2.19
ii  kernel-source- 2.2.19-5       Linux kernel source for version 2.2.19
ii  pcmcia-cs      3.1.22-0.1pota PCMCIA Card Services for Linux.
ii  pcmcia-source  3.1.22-0.1pota PCMCIA Card Services source.

無線LANカード
MELCO WLI-PCM-L11

/etc/pcmcia/config.optsの変更内容
# Options for WaveLAN/IEEE driver (ad-hoc mode)...
#module "wvlan_cs" opts "port_type=3 channel=1 station_name=MY_PC"
↓
module "wvlan_cs" opts "port_type=3 channel=1 station_name=MY_PC"

カード挿入時のsyslog
Nov 21 23:47:01 navi cardmgr[167]: initializing socket 0
Nov 21 23:47:01 navi cardmgr[167]: socket 0: MELCO WLI-PCM-L11
Nov 21 23:47:02 navi cardmgr[167]: executing: 'modprobe wvlan_cs port_type=3 channel=1 station_name=MY_PC'
Nov 21 23:47:02 navi cardmgr[167]: executing: './network start wvlan0'
Nov 21 23:47:02 navi cardmgr[167]: + ioctl: Operation not supported

カード挿入時のiwconfig
wvlan0    IEEE 802.11-DS  ESSID:"non-specified SSID !!"  Nickname:"MY_PC"
          Frequency:2.412GHz  Sensitivity:1/3  Mode:Ad-Hoc  
          Access Point: 00:00:00:00:00:00
          Bit Rate:2Mb/s   RTS thr:off   Fragment thr:off   
          Power Management:off
          Link quality:0  Signal level:0  Noise level:0
          Rx invalid nwid:0  invalid crypt:0  invalid misc:0

カード挿入時のifconfig
wvlan0    Link encap:Ethernet  HWaddr 00:60:1D:F7:22:1D  
          inet addr:192.168.36.21  Bcast:192.168.36.255  Mask:255.255.255.0
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:0 errors:0 dropped:0 overruns:0 frame:0
          TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:100 
          RX bytes:0 (0.0 b)  TX bytes:0 (0.0 b)
          Interrupt:3 Base address:0x100 
-----PC2-----


     禮田 知実 - Tomomi Reita -
   .
.<◎>.  lain@xxxxxxxxxxxxxxxxxxxxxx
 _Π_  Close the world,txEn eht nepO.