[debian-users:35900] Re: USB Floppy Disk Drive のマウント

[Taka Kobane <taka@xxxxxxxxxx>]

早速のお返事ありがとうございます。

> USBのストレージはSCSIのように見えるので、レガシーデバイスの/dev/fd0の
> 代わりに、/dev/sdaあたりで認識されているのでは。

確かに下記の通りUSB Floppy Disk DriveはSCSIとして認識されているようですが、
/dev/sda, /dev/sdb等いろいろ試してみましたが、マウントできません。

   Host scsi0: usb-storage
       Vendor: TEAC    
      Product: TEAC FD-05PUB   
Serial Number: None
     Protocol: Uniform Floppy Interface (UFI)
 

         GUID: 064400000000000000000000
     Attached: Yes
 
> 僕もこの経験があります。
> cat /proc/partitions
> あたりで調べてみると見えるかも。

ハードディスク内のパーティションしか見えませんでした。

参考までに、dmesgでチェックしたところ。なにやらエラーがたくさんでていました。
下記の通りです。

hub.c: new USB device 00:07.2-1, assigned address 2
usb-storage: act_altsettting is 0
usb-storage: id_index calculated to be: 58
usb-storage: Array length appears to be: 68
usb-storage: USB Mass Storage device detected
usb-storage: Endpoints: In: 0xc123eee0 Out: 0xc123eef4 Int: 0xc123ef08 (Period 255)
usb-storage: New GUID 064400000000000000000000
usb-storage: Transport: Control/Bulk/Interrupt
usb-storage: Protocol: Uniform Floppy Interface (UFI)
usb-storage: Allocating IRQ for CBI transport
usb-storage: usb_submit_urb() returns 0
usb-storage: *** thread sleeping.
scsi0 : SCSI emulation for USB Mass Storage devices
usb-storage: queuecommand() called
usb-storage: *** thread awakened.
usb-storage: Command INQUIRY (6 bytes)
usb-storage: 12 00 00 00 ff 00 f2 cb ac 4c f6 cb
usb-storage: Call to usb_stor_control_msg() returned 12
usb-storage: usb_stor_transfer_partial(): xfer 36 bytes
usb-storage: usb_stor_bulk_msg() returned 0 xferred 36/36
usb-storage: usb_stor_transfer_partial(): transfer complete
usb-storage: CBI data stage result is 0x0
usb-storage: Current value of ip_waitq is: 0
usb-storage: USB IRQ received for device on host 0
usb-storage: -- IRQ data length is 2
usb-storage: -- IRQ state is 0
usb-storage: -- Interrupt Status (0x0, 0x0)
usb-storage: -- Current value of ip_waitq is: -1
usb-storage: Got interrupt data (0x0, 0x0)
usb-storage: Fixing INQUIRY data to show SCSI rev 2
usb-storage: scsi cmd done, result=0x0
usb-storage: *** thread sleeping.
  Vendor: TEAC      Model: FD-05PUB          Rev: 2000
  Type:   Direct-Access                      ANSI SCSI revision: 02
usb-storage: queuecommand() called
usb-storage: *** thread awakened.
usb-storage: Bad target number (1/0)
usb-storage: *** thread sleeping.
usb-storage: queuecommand() called
usb-storage: *** thread awakened.
usb-storage: Bad target number (2/0)
usb-storage: *** thread sleeping.
usb-storage: queuecommand() called
usb-storage: *** thread awakened.
usb-storage: Bad target number (3/0)
usb-storage: *** thread sleeping.
usb-storage: queuecommand() called
usb-storage: *** thread awakened.
usb-storage: Bad target number (4/0)
usb-storage: *** thread sleeping.
usb-storage: queuecommand() called
usb-storage: *** thread awakened.
usb-storage: Bad target number (5/0)
usb-storage: *** thread sleeping.
usb-storage: queuecommand() called
usb-storage: *** thread awakened.
usb-storage: Bad target number (6/0)
usb-storage: *** thread sleeping.
usb-storage: queuecommand() called
usb-storage: *** thread awakened.
usb-storage: Bad target number (7/0)
usb-storage: *** thread sleeping.
WARNING: USB Mass Storage data integrity not assured
USB Mass Storage device found at 2
　

小羽根