[debian-users:47602] Re: Can't input Japanese on Etch

[Tomoo Nomura <nomurat@xxxxxxxxx>]

>
> 長南洋一 san,
I suppose gnome might miss the current locale. Because,
------------------------------
tom-lin@nomura:~$ locale
LANG=ja_JP.UTF-8
LC_CTYPE=C
LC_NUMERIC="ja_JP.UTF-8"
LC_TIME="ja_JP.UTF-8"
LC_COLLATE=C
LC_MONETARY="ja_JP.UTF-8"
LC_MESSAGES="ja_JP.UTF-8"
LC_PAPER="ja_JP.UTF-8"
LC_NAME="ja_JP.UTF-8"
LC_ADDRESS="ja_JP.UTF-8"
LC_TELEPHONE="ja_JP.UTF-8"
LC_MEASUREMENT="ja_JP.UTF-8"
LC_IDENTIFICATION="ja_JP.UTF-8"
LC_ALL=
-----------------------------------

However, gnome-terminal->Terminal->Character code->current locale

It is ANSI_X3.4-1968.

Where does gnome aware current locale ?
Can I compulsory set the locale as ja_JP.UTF-8 in gnome session ?

Regards,
Tomoo Nomura

PS. The system is amd64.

-- 
****** Nomura Technical Management Office Ltd. *****************
 Tomoo Nomura      nomura@xxxxxxxxx       http://www.tmo.co.jp/ 
    Phone: +81-78-797-0240 Fax: +81-78-797-0241
 Worldwide Airline Timetable 'Flight Planner'
 European Electronic Timetable 'HAFAS'         ValueFax Support
****************************************************************