[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[debian-users:37512] Re: scsi raid



竹島です。

dmesgの全文を載せます

> 堀内です。
> あの、若し良かったら、参考までにどこのメーカのどういう型番のRAIDカードか、お教え願えませんでしょうか。

tuyosi@sarge:~$ dmesg | more
Linux version 2.2.20 (herbert@gondolin) (gcc version 2.7.2.3) #1 Sat Apr 20 11:45:28 EST 2002
BIOS-provided physical RAM map:
 BIOS-e820: 0009f000 @ 00000000 (usable)
 BIOS-e820: 07f00000 @ 00100000 (usable)
Detected 299153 kHz processor.
Console: colour VGA+ 80x25
Calibrating delay loop... 596.37 BogoMIPS
Memory: 127084k/131072k available (1756k kernel code, 412k reserved, 1668k data, 152k init)
Dentry hash table entries: 16384 (order 5, 128k)
Buffer cache hash table entries: 131072 (order 7, 512k)
Page cache hash table entries: 32768 (order 5, 128k)
VFS: Diskquotas version dquot_6.4.0 initialized
Intel machine check architecture supported.
Intel machine check reporting enabled on CPU#0.
512K L2 cache (4 way)
CPU: L2 Cache: 512K
CPU: Intel Pentium II (Klamath) stepping 04
Checking 386/387 coupling... OK, FPU using exception 16 error reporting.
Checking 'hlt' instruction... OK.
Checking for popad bug... OK.
POSIX conformance testing by UNIFIX
mtrr: v1.35a (19990819) Richard Gooch (rgooch@xxxxxxxxxxxxx)
PCI: PCI BIOS revision 2.10 entry at 0xf7d7d
PCI: Using configuration type 1
PCI: Probing PCI hardware
PCI: 00:00 [8086/1237]: Passive release enable (00)
Linux NET4.0 for Linux 2.2
Based upon Swansea University Computer Society NET3.039
NET4: Linux TCP/IP 1.0 for NET4.0
IP Protocols: ICMP, UDP, TCP, IGMP
TCP: Hash tables configured (ehash 131072 bhash 65536)
Starting kswapd v 1.5 
Serial driver version 4.27 with HUB-6 MANY_PORTS MULTIPORT SHARE_IRQ enabled
ttyS00 at 0x03f8 (irq = 4) is a 16550A
ttyS01 at 0x02f8 (irq = 3) is a 16550A
pty: 256 Unix98 ptys configured
Real Time Clock Driver v1.09
RAM disk driver initialized:  16 RAM disks of 4096K size
loop: registered device at major 7
Floppy drive(s): fd0 is 1.44M
FDC 0 is a National Semiconductor PC87306
md driver 0.36.6 MAX_MD_DEV=4, MAX_REAL=8
(scsi0) <Adaptec AIC-7880 Ultra SCSI host adapter> found at PCI 1/10/0
(scsi0) Wide Channel, SCSI ID=7, 16/255 SCBs
(scsi0) Downloading sequencer code... 422 instructions downloaded
(scsi1) <Adaptec AIC-7860 Ultra SCSI host adapter> found at PCI 1/11/0
(scsi1) Narrow Channel, SCSI ID=7, 3/255 SCBs
(scsi1) Downloading sequencer code... 436 instructions downloaded
scsi: <fdomain> Detection failed (no card)
NCR53c406a: no available ports found
sym53c416.c: Version 1.0.0
Failed initialization of WD-7000 SCSI card!
IBM MCA SCSI: Version 3.2
IBM MCA SCSI: No Microchannel-bus present --> Aborting.
              This machine does not have any IBM MCA-bus
              or the MCA-Kernel-support is not enabled!
megaraid: v1.11 (Aug 23, 2000)
megaraid: found 0x101e:0x9010:idx 0:bus 1:slot 13:func 0
scsi2 : Found a MegaRAID controller at 0xe090, IRQ: 11
megaraid: [U.77:1.47] detected 1 logical drives
aec671x_detect: 
3ware Storage Controller device driver for Linux v1.02.00.008.
3w-xxxx: tw_findcards(): No cards found.
scsi0 : Adaptec AHA274x/284x/294x (EISA/VLB/PCI-Fast SCSI) 5.1.33/3.2.4
       <Adaptec AIC-7880 Ultra SCSI host adapter>
scsi1 : Adaptec AHA274x/284x/294x (EISA/VLB/PCI-Fast SCSI) 5.1.33/3.2.4
       <Adaptec AIC-7860 Ultra SCSI host adapter>
scsi2 : AMI MegaRAID U.77 254 commands 16 targs 2 chans 8 luns :これだと思います。
scsi : 3 hosts.
  Vendor: NEC       Model: CD-ROM DRIVE:464  Rev: 1.05
  Type:   CD-ROM                             ANSI SCSI revision: 02
Detected scsi CD-ROM sr0 at scsi1, channel 0, id 5, lun 0
  Vendor: SONY      Model: SDT-9000          Rev: 125F
  Type:   Sequential-Access                  ANSI SCSI revision: 02
scsi2: scanning channel 1 for devices.
  Vendor: DELL      Model: 6UW BACKPLANE     Rev: 7   
  Type:   Processor                          ANSI SCSI revision: 02
scsi2: scanning channel 2 for devices.
scsi2: scanning virtual channel for logical drives.
  Vendor: MegaRAID  Model: LD0 RAID5 12654R  Rev: U.77
  Type:   Direct-Access                      ANSI SCSI revision: 02
Detected scsi disk sda at scsi2, channel 2, id 0, lun 0
scsi : detected 1 SCSI cdrom 1 SCSI disk total.
(scsi1:0:5:0) Synchronous at 10.0 Mbyte/sec, offset 15.
Uniform CD-ROM driver Revision: 3.11
SCSI device sda: hdwr sector= 512 bytes. Sectors= 25915392 [12654 MB] [12.7 GB]
Partition check:
 sda: sda1 sda2
apm: BIOS not found.
VFS: Mounted root (ext2 filesystem) readonly.
Freeing unused kernel memory: 152k freed
NET4: Unix domain sockets 1.0 for Linux NET4.0.
Adding Swap: 497972k swap-space (priority -1)
eepro100.c:v1.09j-t 9/29/99 Donald Becker http://cesdis.gsfc.nasa.gov/linux/drivers/eepro100.html
eepro100.c: $Revision: 1.20.2.10 $ 2000/05/31 Modified by Andrey V. Savochkin <saw@xxxxxxxxxxxxx> and others
eepro100.c: VA Linux custom, Dragan Stancevic <visitor@xxxxxxxxxxx> 2000/11/15
eth0: Intel PCI EtherExpress Pro100 82557, 00:A0:C9:11:59:44, IRQ 10.
  Receiver lock-up bug exists -- enabling work-around.
  Board assembly 352509-003, Physical connectors present: RJ45
  Primary interface chip DP83840 PHY #1.
  DP83840 specific setup, setting register 23 to 8462.
  General self-test: passed.
  Serial sub-system self-test: passed.
  Internal registers self-test: passed.
  ROM checksum self-test: passed (0x49caa8d6).
  Receiver lock-up workaround activated.
eth1: Intel PCI EtherExpress Pro100 82557, 00:A0:C9:A9:E0:59, IRQ 14.
  Receiver lock-up bug exists -- enabling work-around.
  Board assembly 667280-004, Physical connectors present: RJ45
  Primary interface chip i82555 PHY #1.
  General self-test: passed.
  Serial sub-system self-test: passed.
  Internal registers self-test: passed.
  ROM checksum self-test: passed (0x49caa8d6).
  Receiver lock-up workaround activated.


なお、
tuyosi@sarge:~$ df
Filesystem           1k-blocks      Used Available Use% Mounted on
/dev/sda2             12262868    573828  11066120   5% /
です。


HP   nakajin.dyndns.org
Mail nakazintuyosi@xxxxxxxxxxxxxxxxxx
なんでも飛んで来ますインターネット、でfirewallで戸締り