[debian-users:52827] Buffalo WLI3-CB-G54L

[sasa <sasalinux@xxxxxxxxxxxxxx>]

こんにちは、先日はお世話になりました。

その先日のWLI3-CB-G54Lなんですが、また接続が出来なくなってしまいました。
firmwareを入れなおすことで暫くは繋がるようにはなっていましたが
その際もずっとPHY Transmisson Errorが出ており、
その後いよいよ繋がらなくなってしまいました。

環境はDebian/lenny(kernel 2.6.26-1-686)
カードのチップセットはbroadcom bcm4318
http://linuxwireless.org/en/users/Drivers/b43#firmware_installation
を参考にb43-fwcutter-012でfwを切り出しています

[   40.879214] input: b43-phy0 as /class/input/input7
[   40.984114] firmware: requesting b43/ucode5.fw
[   41.089749] firmware: requesting b43/pcm5.fw
[   41.151679] firmware: requesting b43/b0g0initvals5.fw
[   41.251666] firmware: requesting b43/b0g0bsinitvals5.fw
[   41.436061] b43-phy0: Loading firmware version 410.2160 (2007-05-26 
15:32:10)
[   42.560842] Registered led device: b43-phy0::tx
[   42.584011] Registered led device: b43-phy0::rx
[   42.600109] Registered led device: b43-phy0::radio
[   45.752877] NET: Registered protocol family 10
[   45.776000] lo: Disabled Privacy Extensions
[   45.796017] ADDRCONF(NETDEV_UP): wlan0: link is not ready
[   62.400182]  CIFS VFS: Error connecting to IPv4 socket. Aborting 
operation
[   62.418949]  CIFS VFS: cifs_mount failed w/return code = -113
[   68.512168]  CIFS VFS: Error connecting to IPv4 socket. Aborting 
operation
[   68.531160]  CIFS VFS: cifs_mount failed w/return code = -113
[   70.101259] RPC: Registered udp transport module.
[   70.119809] RPC: Registered tcp transport module.
[   70.515910] Installing knfsd (copyright (C) 1996 okir@xxxxxxxxxxxx).
[   76.119753] lp0: using parport0 (interrupt-driven).
[   76.221348] ppdev: user-space parallel port driver
[  152.072759] warning: `ntpd' uses 32-bit capabilities (legacy support 
in use)
[  164.648538] wlan0: Initial auth_alg=0
[  164.648565] wlan0: authenticate with AP 00:0a:79:d8:9c:c8
[  164.848086] wlan0: authenticate with AP 00:0a:79:d8:9c:c8
[  165.048091] wlan0: authenticate with AP 00:0a:79:d8:9c:c8
[  165.248074] wlan0: authentication with AP 00:0a:79:d8:9c:c8 timed out
[  170.549249] wlan0: authentication frame received from 00:0a:79:d8:9c:
c8, but not in authenticate state - ignored
[  171.575405] wlan0: authentication frame received from 00:0a:79:d8:9c:
c8, but not in authenticate state - ignored
[  172.701424] wlan0: authentication frame received from 00:0a:79:d8:9c:
c8, but not in authenticate state - ignored

sambaのマウントに失敗しているのはさておき
認証のタイミングがおかしいとにらんでいます
fwを入れなおすだけで改善したのも解せないのですが
改善する方法はないでしょうか？